Drawing: Cobra helicopter Drawing: Cobra helicopter
Chapter 8 - Page 11

Gill Net

If a gill net is not available, you can make one using parachute suspension line or similar material (Figure 8-19). Remove the core lines from the suspension line and tie the easing between two trees. Attach several core lines to the easing by doubling them over and tying them with prusik knots or girth hitches. The length of the desired net and the size of the mesh determine the number of core lines used and the space between them. Starting at one end of the easing, tie the second and the third core lines together using an overhand knot. Then tie the fourth and fifth, sixth and seventh, and so on, until you reach the last core line. You should now have all core lines tied in pairs with a single core line hanging at each end. Start the second row with the first core line, tie it to the second, the third to the fourth, and so on.

Drawing: Figure 8-19. Making a gill net

To keep the rows even and to regulate the size of the mesh, tie a guideline to the trees. Position the guideline on the opposite side of the net you are working on. Move the guideline down after completing each row. The lines will always hang in pairs and you always tie a cord from one pair to a cord from an adjoining pair. Continue tying rows until the net is the desired width. Thread a suspension line easing along the bottom of the net to strengthen it. Use the gill net as shown in Figure 8-20.

Drawing: Figure 8-20. Setting a gill net in the stream

<< Previous Page Page: 1  2  3  4  5  6  7  8  9  10  11  12  13  14  15 Next Page >>

Back to The Home Page Bact To The Survival Table Of Content Your Free E-Mail Log In Page

Google
 
Web Aircav.com
Updated: 12 January 2008
Born on 28 October 1999